Our Tool Bits are made from the finest grades of steel imported from Western Europe and Japan. These are then tested in our well equipped laboratory for physical appearance, surface finishes, dimensions, grain size, chemical composition, other variables and defects before further processing - that includess a whole battery of tests, from checking of chemical composition to microscopic tests for carbide distribution. It is made sure that raw materials used meet with our requirements.

Heat-treatment is what transforms a soft, pliable piece of steel into hard, tough and wear resistant tool bit. This is the factor where there is no chance for compromise on quality. We have therefore opted for furnaces manufactured under German License to ensure precise automatic temperature control and of course very close process control. Even then each batch is carefully tested for microstructure and each tool for hardness in well equipped laboratory and quality control department. After well - controlled further processing what we have is tool bit to give you the best in every desired quality.

Our range of HSS Tool Bits & Cut-off Blades

High Speed Steel Tool Bits Square, Round, Rectangular/ Flat High Speed Steel Cut-Off Blades Single Bevelled Tapered Ground, Double Bevelled Tapered Ground, P-Shaped/ T-Type & Parting Off	T101 - M2
	T102 - M35 (5% Cobalt)
	T103 - M42 (8% Cobalt)
	T104 - T42 (10% Cobalt)